Assembling The Drive; Assembling The Rotor - Dürkopp Adler 867-M PREMIUM Service Instructions Manual

Integrated motor
To disassemble the rotor:
1. Remove the arm cover ( p. 17).
2. Loosen the threaded pins (1), (2).
3. Remove the rotor with deep groove ball bearing (3).

19.3 Assembling the drive

19.3.1 Assembling the rotor

Fig. 82: Assembling the rotor
(1) - Threaded pins
(2) - Threaded pins
To fit the rotor:
1. Push the rotor with deep groove ball bearing (3) onto the shaft until the
2. Screw all threaded pins (1), (2) firmly in place, observing the surface
Service Instructions 867-M PREMIUM - 03.0 - 05/2017
①
deep groove ball bearing is resting against the stop.
of the shaft in doing so: Screw the first screw in the direction of rotation
firmly in place on the surface.
② ③
(3) - Rotor with deep groove ball bearing
95