Setting The Needle Cooling (Needlecooling) Parameter; Setting The Seam Center Guide (Centerguide) Parameter - Dürkopp Adler 867-M PREMIUM Service Instructions Manual

Programming

20.5.12 Setting the Needle cooling (NeedleCooling) parameter

Various settings can be made for the needle cooling. The possibilities are
explained in more detail in the table.
Menu item
OFF
ON
At Speed
Edge Trimmer Needle cooling is activated when the edge cutter is also activated.

20.5.13 Setting the Seam center guide (CenterGuide) parameter

The seam center guide is optional additional equipment on 2-needle ma-
chines. When the seam center guide is activated, the following settings
can be made.
Menu item
Auto Mode
RaiseOnHP
Service Instructions 867-M PREMIUM - 03.0 - 05/2017
Setting options
Needle cooling is deactivated.
Needle cooling is activated.
t Delay
Lag time, after which the needle cooling is deactivated.
(Value range 00.0 – 10.0 [ms])
t Delay
Lag time, after which the needle cooling is deactivated.
(Value range 00.0 – 10.0 [ms])
CoolSpeed
Speed at which the needle cooling is activated.
(Value range 0000 – 6000 [rpm])
t Delay
Lag time, after which the needle cooling is deactivated.
(Value range 00.0 – 10.0 [ms])
Setting options
Mode for automatic raising of the seam center guide.
OFF
Raising of the seam center guide is deactivated; it is not raised
automatically.
On Tack
Raising of the seam center guide when sewing the bartack.
On Lift
Raising of the seam center guide when lifting the sewing foot.
Tack+Lift
Raising of the seam center guide when sewing the bartack and lifting
the sewing foot.
When the second stroke height is activated, the seam center guide is
automatically raised.
(Value range ON/OFF)
115