Setting The Stroke Movement For The Feeding Foot - Dürkopp Adler 867-M PREMIUM Service Instructions Manual

12.3 Setting the stroke movement for the feeding foot

Fig. 46: Setting the stroke movement for the feeding foot (1)
(1) - Feeding foot
(2) - Feed dog
Order
First, check the following settings:
Proper setting
The feeding foot (1) touches down exactly on the feed dog (2) when the
downward movement of the needle tip (3) reaches the upper edge of the
feeding foot. This will occur when the handwheel is in the 95° position.
To set the stroke movement for the feeding foot:
1. Execute the service routine Stroke > Feed Move ( p. 14).
 The software is used to define the necessary presettings on the
2. Remove the arm cover ( p. 17).
Fig. 47: Setting the stroke movement for the feeding foot (2)
(4) - Stroke eccentric
58
①
②
• Feed dog movement ( p. 38)
• Sewing foot stroke( p. 57)
machine.
④
⑤
③
(3) - Needle tip
(5) - Threaded pins
Service Instructions 867-M PREMIUM - 03.0 - 05/2017
Sewing feet