Dürkopp Adler 867-M PREMIUM Service Instructions Manual page 68

Setting the winder spacing
Fig. 53: Setting the winder (2)
(3) - Winder lever
(5) - Thread-pulling knife
(6) - Winder spindle
(7) - Right-hand screw hole
Fig. 54: Setting the winder (3)
(11) - Marking for XXL hook
To set the winder spacing:
7. Turn the winder spindle (6) such that the thread-pulling knife (5) is at
8. Loosen the threaded pin in the block (8).
9. Set the winder lever (3) such that the upper arm is above the marking
 The distance between the winder lever and the outer thread on the
10. Set the block (8) such that it is resting against the locking disk (9).
11. Set the block (8) such that its distance to the winder wheel (10) is
12. Tighten the threaded pin in the block (8).
66
⑤
⑥
⑦
the top right and is facing the right-hand screw hole (7).
for the XXL hook (11).
bobbin is 2 – 3 mm.
0.5 mm.
⑩
③ ⑧
(8) - Block
(9) - Locking disk
(10) - Winder wheel
⑪
Service Instructions 867-M PREMIUM - 03.0 - 05/2017
Winder
⑨
⑤
⑥