Execution Type Setting And Example Of Type Changing - Mitsubishi Q00JCPU User Manual

3
SEQUENCE PROGRAM CONFIGURATION AND
EXECUTION CONDITIONS
3.3.6 Execution type setting and example of type
Basic
Note3.29
(1) Execution type setting
Redundant Universal
UD
Note3.30
Note27
Basic
Since the Basic model QCPU cannot execute multiple programs, the execution type setting and
instruction-triggered changing are not available.
Note3.29
Note28
Redundant
Universal Since the Redundant CPU and Universal model QCPU cannot use low speed execution type
UD
programs, "Low speed" cannot be selected as the execution type.
Note3.30
Program setting necessary for executing multiple programs is explained in this
section. Set the program execution type in the program of the PLC parameter dialog
box of GX Developer.
The CPU module executes the programs of set execution types in the setting order.
(a) Program name
Set the program name (file name) of the program to be executed by the CPU
module.
(b) Execution type
Select the execution type of the file set in Program name.
1) Initial execution type (Initial)
This program is executed only once when the PLC is powered ON or is
switched from STOP to RUN.(
2) Scan execution type (Scan)
This program is executed once for each scan, starting at the scan after
execution of the initial execution type program.(
3) Low speed execution type (Low speed)
This program is executed only when the constant scan or low speed type
program execution time is set.(
3.3 Settings for Creation and Execution of Multiple Sequence Programs

3.3.6 Execution type setting and example of type changing

changingNote27
Figure 3.51 Program
Section 3.3.1)
Note3.30
Note28
Section 3.3.3)
(a)
(b)
(b) 5)
(b) 5)
Programs
are executed
in setting
order.
(c)
(d)
Section 3.3.2)
3
- 57
1
2
3
4
5
6
7
8