Mitsubishi Q00JCPU User Manual page 784

12
PROCEDURE FOR WRITING PROGRAM TO CPU
MODULE
12
- 13 12.2 High Performance Model QCPU, Process CPU, Redundant CPU, Universal Model QCPU
12.2.3 Procedure for writing one program
Choose [Online]
memory] on GX Deveoper, and format
the program memory.
Choose [Online]
Deveoper, and write the parameters,
created program and device initial values.
Power the PLC OFF and then ON, or
reset the CPU module.
Set the RUN/STOP switch to the RUN
position to place the PLC in the RUN
status.
NO
ERR. LED of the
Choose [Diagnostics]
on GX Developer or perform [PLC
Diagnostics] to check the error factor, and
remove the error factor.
NO
To Section 12.2.5
End
* 2 : Refer to the following manual for the procedure when the Redundant CPU is used.
QnPRHCPU User's Manual (Redundant System)
* 3 : When storing the file register and device initial value data into the standard RAM or memory card
(except the Flash card), also format the standard RAM or memory card.
* 4 : Write each data to the following memory.
•Program ..... Program memory
•Parameter ..... Memory set as the parameter-valid drive with the DIP switches
•Device initial value ..... Memory specified in the PLC file setting of the PLC parameter dialog box
* 5 : RUN/STOP/RESET switch for the Universal model QCPU.
Figure 12.5 Flowchart for writing one program
POINT
In the MELSECNET/H system where the Universal model QCPU No.1 is the
control CPU, the Universal model QCPU can communicate with the QnUCPU
where MISSING PARA. has been occurred via the MELSECNET/H. (For the
network No.1 only.)
2)
[Format PLC
[Write to PLC] on GX
Is the
CPU module on
(flickering)?
YES
[System Monitor]
Is boot run
executed?
YES
3
Write to PLC screen
4
............
2
QCPU User's Manual
(Hardware Design, Maintenance
and Inspection)
5
QCPU User's Manual
(Hardware Design, Maintenance
and Inspection)