Mitsubishi Q00JCPU User Manual page 464

6
FUNCTIONS
(2) Priorities and factor Nos.
Priority
1
2
3
4
5
6
7
8
9
10
11
6
- 164 6.21 LED Display
6.21.2 Priority setting
The description and default priority for the factor Nos. to be set in the special registers
SD207 to 209 are as follows:
Table6.42 List of default factor Nos. and priorities
Factor
*1
Displayed error message
number
(Hexadecimal)
AC/DC DOWN
1 SINGLE PS.DOWN
SINGLE PS.ERROR
UNIT VERIFY ERR.
FUSE BREAK OFF
2
SP.UNIT ERROR
SP.UNIT DOWN
OPERATION ERROR
3 SFCP OPE.ERROR
SFCP EXE.ERROR
ICM.OPE.ERROR
FILE OPE.ERROR
OPE. MODE DIFF.
CAN'T EXE.MODE
4
TRK.TRANS.ERR.
TRK.SIZE ERROR
TRK.DISCONNECT
FLASH ROM ERROR
PRG.TIME OVER
5
MULTI CPU ERROR
6
CHK instruction
7 Annunciator
8
9 BATTERY ERROR
A
CAN'T SWITCH
B
STANDBY SYS.DOWN
MEM.COPY EXE.
* 1: The Basic model QCPU can set the priority only for the factor number 7 (annunciator).
* 2: Confirm the version of CPU module for actions to be taken in the High Performance model QCPU
and Process CPU. (
model QCPU.
* 3: The error message is not displayed in the Basic model QCPU, High Performance model QCPU,
Process CPU, and Universal model QCPU.
* 4: The error message is not displayed in the Basic model QCPU, High Performance model QCPU,
Process CPU, and Redundant CPU.
* 5: Since the Redundant CPU and Universal model QCPU do not support low-speed execution type
programs, a low-speed execution monitoring timeout error does not occur.
* 6: The Basic model QCPU and Universal model QCPU do not support the CHK instruction.
• Power shutoff
*2
• Redundant base unit power supply voltage drop
*2
• Redundant power supply module fault
• Module verification error
• Fuse shutoff
• Intelligent function module verify error
• Calculation error
• SFC instruction calculation error
• SFC program execution error
• Memory card operation error
• File access error
*3
• Operation status, switch mismatch
*3
• Current mode-time function execution disabled
*3
• Tracking data transmission error
*3
• Tracking capacity excess error
*3
• Tracking cable not connected, failure
*4
• Flash ROM access count over error
• Constant scan setting timeout error
• Low-speed execution monitoring timeout error
• Other CPU error in the multiple CPU system configuration
*6
--
--
*3
• System switching error
*3
• Standby system not started/stop error
*3
• Memory copy function executed
Appendix 4) The error message is not displayed in the Universal
Remarks
*5
--
--
--
--
--