Mitsubishi Q00JCPU User Manual page 360

Hide thumbs Also See for Q00JCPU:

Table of Contents

(2) Explanation of specifications

6.11 Monitor Function

6.11.3 Forced ON/OFF for external I/O

(a) Status of the CPU module for which forced ON/OFF is available

Forced ON/OFF can be registered regardless of the status (RUN/STOP) of the

Note, however, that only input can be forcibly turned ON/OFF during a stop error.

Output is performed only to device Y.

(b) Registerable devices

The number of devices as many as CPU module's I/O device points can be

Inputs and outputs targeted for forced ON/OFF are described below.

• I/O (X/Y) of modules on main base unit.

• I/O (X/Y) of CPU module to which LX/LY of CC-Link IE controller network

module or MELSECNET/H module is refreshed

• I/O (X/Y) of CPU module to which RX/RY of CC-Link to be refreshed

When forcibly turning ON/OFF the devices outside the above refresh ranges (ex:

empty slots), only I/O in the CPU module device memory are turned ON/OFF, and

the results are not output externally.

In a multiple CPU system, inputs and outputs of controlled modules are targeted

for forced ON/OFF.

Even when inputs and outputs of non-controlled modules are registered for forced

ON/OFF, I/O devices in other CPU modules and I/O of modules controlled by

other CPU modules are not forcibly turned ON/OFF.

(I/O devices in host CPU module turn ON/OFF.)

For details on the multiple CPU system, refer to the following manual.

QCPU User's Manual (Multiple CPU System)

The Basic model QCPU does not support the forced ON/OFF registration operation from the

Forced input output registration/cancellation screen (

The Basic model QCPU can forcibly turns ON/OFF external I/O only by executing a device test in

GX Developer.

(3) in this section).

Show Quick Links

Table of Contents