Mitsubishi Q00JCPU User Manual page 300

5
MEMORIES AND FILES HANDLED BY CPU MODULE
(High Performance model QCPU)
(Process CPU)
5
- 76 5.4 File Operation by GX Developer and Handling Precautions
5.4.4 File size units
POINT
The file size unit of the following CPU modules has been changed.
• High Performance model QCPU whose first 5 digits of serial No. is
"04122" or later.
• Process CPU whose first 5 digits of serial No. is "07032" or later.
Hence, note the following points.
1. Depending on the file capacity, the file executed by the CPU module of above
serial No. or later may not be stored into the CPU module of above serial No.
or before.
2. Combination of PLC write and GX Developer
The following table indicates the combination of High Performance model
QCPU/Process CPU and GX Developer versions when a file is read from the
High Performance model QCPU/Process CPU to GX Developer and then
written to another High Performance model QCPU/Process CPU.
Write destination
File executed by CPU
of serial No. "04122"
Serial No. "04122" or
later
Serial No. "04121" or
earlier
* 1 : Because of different file size units, the file may not be stored into the High Performance model
QCPU depending on the file capacity.
* 2 : Unless the number of allocate memory for online change is decreased, the file may not be stored
into the High Performance model QCPU depending on the file capacity.
Write destination
File executed by CPU
of serial No. "07032"
Serial No. "07032" or
later
Serial No. "07031" or
earlier
* 1 : Because of different file size units, the file may not be stored into the High Performance model
QCPU depending on the file capacity.
* 2 : Unless the number of allocate memory for online change is decreased, the file may not be stored
into the High Performance model QCPU depending on the file capacity.
Legends
GX Developer Version8
File executed by CPU
of serial No. "04121"
or later or earlier
*1
Legends
GX Developer Version8
File executed by CPU
of serial No. "07031"
or later or earlier
*1
: Write to PLC enabled : Restriction on write to PLC
Write source
GX Developer Version7
File executed by CPU
of serial No. "04122"
or later
*2
*1 *2
: Write to PLC enabled : Restriction on write to PLC
Write source
GX Developer Version7
File executed by CPU
of serial No. "07032"
or later
*2
*1 *2
File executed by CPU
of serial No. "04121"
or earlier
*2
*2
File executed by CPU
of serial No. "07031"
or earlier
*2
*2