Installing The Mounting Brackets - HP StorageWorks 2/16 - SAN Switch Installation Manual

Installing the SAN Switch 2/16
Note:
rear of the rack. This mounting allows air to enter from the front of the rack and to
exhaust at the rear of the rack, similar to other rack-mounted equipment. This prevents
switch overheating, which may cause it to fail.
Use these steps to install the switch in the HP System/e rack.
1. Verify that all required hardware is available.
2. Choose a mounting location in the rack for the switch.
3. Install each of the two mounting brackets with one M5 Torx head screw with
Figure 8: Installing the mounting brackets
40
For proper airflow, the SFP media side of the SAN Switch 2/16 must face the
captive lock washers as shown in Figure 8.
hp StorageWorks SAN Switch 2/16 Installation Guide