Installing The Rear Mounting Brackets (Hp 10000 Series Racks); Installing The Rear Mounting Brackets (Hp System/E Rack) - HP StorageWorks 8/24 - SAN Switch Hardware Reference Manual

To install the device in a rack:
1.
Verify that the required parts and hardware are available. See
2.
Choose a mounting location for the device in the rack.
3.
Attach the rear mounting brackets to the rear rack uprights:
• For HP 10000 series racks, assemble each of the two brackets with two #10-32 x 1/2-inch
Phillips pan-head screws with captive star lock-washers and two #10 adapter washers, as
shown in Figure
• For an HP System/e Rack, install the two rear mounting brackets with two #10-32 x 1/2-inch
Phillips pan-head screws and two #10 alignment washers, as shown in
Figure 8 Installing the rear mounting brackets (HP 10000 series racks)
Figure 9 Installing the rear mounting brackets (HP System/e Rack)
NOTE:
Your SAN Switch Rack Mount Kit contains both right rails and left rails. The rails are
labelled Right and Left.
32
Installing and configuring an 8Gb SAN Switch
8.
Table 8.
Figure 9.