Installing The Switch In The Optional Hp System/E Rack - HP AA-RSB6B-TE Installation Manual

Installing the SAN Switch 2/8

Installing the Switch in the Optional HP System/e Rack

Before you begin, locate the following items to install the SAN Switch 2/8 in the
HP System/e Rack Kit:
1. Select a mounting location in the rack for the switch.
2. Attach the rear rail-tray brackets to the rear rack uprights by installing each of
38
SAN Switch 2/8
#2 Phillips and T25 Torx screwdrivers
Caution: F or proper airflow, the SFP media side of the SAN Switch 2/8 must
face the rear of the rack. This mounting allows air to enter the front of the rack
through the plenum and to exhaust at the rear of the rack, preventing
overheating.
the two mounting brackets with one M5 Torx head screw with captive lock
washer as shown in Figure 8.
hp StorageWorks SAN Switch 2/8 Installation Guide