Installing Shelf Brackets In An Hp Rack System/E Or 19-Inch Eia Rack - HP StorageWorks Director 2/140 Installation Manual

NOTE: Center each shelf bracket between the interior vertical rails of the rack cabinet.
Figure 11 Shelf brackets mounted in HP 9000, HP 10000, and HP 11000 Series rack
8. Continue to "Attaching the mounting hardware to the director" on page

Installing shelf brackets in an HP Rack system/e or 19-inch EIA rack

The shelf brackets mount directly to the interior vertical rails of the HP rack system/e or 19-inch EIA
rack using cage nuts and Phillips panhead screws.
NOTE: The four angle brackets are not used in this rack system.
Use these steps to install the two shelf brackets in an HP rack system/e or 19-inch EIA rack.
1. Determine the appropriate placement for the director inside the rack.
NOTE: HP strongly recommends installing the Director 2/140 in the lowest position in the rack.
2. Along an exterior vertical rail of the rack cabinet, determine the position of the bottom of the
shelf bracket and count 1U up from this location.
3. Use a straight edge to locate the corresponding rack holes along the interior vertical rails of the
rack cabinet. Mark this location on each interior vertical rail.
4. Install two cage nuts along one interior vertical rail as marked in
hole between the cage nuts.
36.
step 3, leaving one empty rack
Director 2/140 installation guide 35