Dhcp Relay Agent Port Configuration - Siemens SCALANCE X-300 Configuration Manual

Syntax of the Command Line Interface
Table 4- 75
info
server <number>
[IP][VLANs]
remoteid [IP|MAC]
bcastfwd [E|D]
reachchk
[E|D]
4.5.19.2

DHCP Relay Agent Port Configuration

DHCP Relay Agent Port Parameters
This page displays the currently configured port-specific parameters of the DHCP relay
agent.
Figure 4-102 DHCP Relay Agent Port Parameters
The three columns of the port table show the following information:
Port
Specifies the slot and port to which the information relates. The name of the link aggregation
is shown here if link aggregations are configured.
DHCP Server Selection
Indicates which DHCP servers are responsible for this port.
Neighborhood Detection
Shows whether or not detection of neighbors is enabled for this port.
Only Neighbors
Shows whether the DHCP relay agent functions only for direct neighbors on this port.
SCALANCE X-300 / X-400
Configuration Manual, 10/2014, C79000-G8976-C187-22
Configuration using Web Based Management and Command Line Interface
DHCP Relay Agent Configuration - CLI\SWITCH\RELAGENT>
Command
Shows the current settings of the DHCP relay agent.
Specifies the IP address and the VLANs of the
DHCP server <number>.
Specifies the relay agent remote ID
Enables/disables the "Enable Broadcast Forwarding"
function.
Enables/disables the "Check for Server Reachability"
function.
Description
4.5 The Switch menu
Comment
-
Administrator only.
Default value: 0.0.0.0
Administrator only.
Administrator only.
Administrator only.
233