Siemens SCALANCE X-300 Configuration Manual page 91

Accessible in all VLANs
If this option is enabled, all agent functions (ping, Telnet, Web interface etc.) are accessible
via all VLANs; if it is disabled, the functions are accessible only via the agent VLAN.
ARP to all VLANs
This option is only relevant, it the "Accessible in all VLANs" option is enabled. If this option
is enabled, the management agent sends ARP packets to all VLANs. If it is disabled, the
management agent only sends ARP packets to the VLAN configured in "Agent VLAN ID".
MAC Address
The MAC address of the IE switch or CPU module.
Syntax of the Command Line Interface
Table 4- 20
ip <IP address>
subnet <subnet mask>
gateway <IP address>
vid
SCALANCE X-300 / X-400
Configuration Manual, 10/2014, C79000-G8976-C187-22
Configuration using Web Based Management and Command Line Interface
Agent Configuration - CLI\AGENT>
Command
This specifies in-band IP address for
the IE switch. You enter four decimal
numbers separated by dots.
Displays the currently set in-band IP
address if no parameter is specified.
Specifies the subnet mask for the in-
band ports of the IE switch. You enter
four decimal numbers separated by
dots.
Specifies the IP address of the default
IP gateway. You enter four decimal
numbers separated by dots.
Specifies the agent VLAN ID.
Description
4.4 The Agent menu
Comment
Administrator only.
The IP address must be entered
if you want to access an IE
switch using a Web browser,
TELNET, or SNMP. The IP
address can also be assigned
automatically by BOOTP/DHCP.
Administrator only.
The subnet mask must be en-
tered if you want to access an
IE switch using a Web browser,
TELNET, or SNMP.
The IP address can also be
assigned automatically by
BOOTP/DHCP.
Administrator only.
The IP address must be entered
if you want to access a router on
the IE switch and the communi-
cation partner does not belong
to the same subnet as the IE
switch. The gateway must either
be in the subnet of the in-band
IP address or the out-band IP
address.
The IP address can also be
assigned automatically by
BOOTP/DHCP.
Administrator only.
Default value: 1
91