Siemens SCALANCE X-300 Configuration Manual page 88

Configuration using Web Based Management and Command Line Interface
4.4 The Agent menu
If an IE switch has an IP address and there is an Ethernet connection to a PC or PG, follow
the steps below to download configuration data:
1. Open a console window and type in the command ftp followed by the IP address of the IE
switch. Example:
ftp 192.168.20.54
2. For the login and password enter the same values as you use for WBM and CLI.
3. Enter the "put" command followed by the name of the firmware file.
Example:
put cfgdata.txt
4. Once the file has been loaded, the IE switch closes the FTP connection and restarts.
TELNET
Here, you specify whether or not the IE switch is accessible over TELNET.
SSH
Here, you specify whether or not the IE switch is accessible over SSH.
HTTPS only
Here, you specify whether or not the IE Switch is reachable only over HTTPS. If you do not
select this option, it can also be reached with HTTP.
E-mail
This enables / disables the e-mail function of the IE switch. For detailed information on this
functionality, refer to the section "Agent E-Mail Configuration menu item".
Syslog
Here, you specify whether or not the IE switch stores log entries on a Syslog server. For
detailed information on this functionality, refer to the section "Agent Syslog Configuration
menu item".
RMON
An IE switch supports remote monitoring (RMON). Remote Monitoring allows diagnostic data
to be collected on the IE switch, prepared and read out using SNMP by a network
management station that also supports RMON. This diagnostic data, for example port-
related load trends, allow problems in the network to be detected early and eliminated. The
setting for RMON does not influence the statistics functions (see section "Statistics menu").
88
Configuration Manual, 10/2014, C79000-G8976-C187-22
SCALANCE X-300 / X-400