Siemens SCALANCE X-300 Configuration Manual page 212

Configuration using Web Based Management and Command Line Interface
4.5 The Switch menu
Configuration of a port for Multiple Spanning Tree
If you click on a port name in the "Port" column of the "CIST Port Parameters" page, you
open the "Spanning Tree Port Configuration" page.
Figure 4-89
The port-specific configuration of the CIST port parameters is also adopted for STP and
RSTP. This configuration is therefore the same in MSTP, RSTP and STP.
You will find the description of the individual page elements and CLI commands in the
section Spanning Tree Port Configuration (Page 202).
Syntax of the Command Line Interface
Table 4- 65
info
stpport [<E|D> [ports]]
prio [<0..255> [ports]]
pathcost [<0..65535> [ports]]
admedge [<T|F> [ports]]
212
Spanning Tree Port Configuration
CIST Port Parameters - CLI\SWITCH\MSTP\CISTPORTS>
Command
Shows an overview of the ports and the corre-
sponding rapid spanning tree settings.
Enables/disables spanning tree for the relevant
port.
Specifies the priority of the relevant port.
Specifies the path costs for the relevant port.
Specifies whether an end device or a switch is
connected to the relevant port:
•
•
Description
T
End device
F
Switch
Configuration Manual, 10/2014, C79000-G8976-C187-22
Comment
-
Administrator
only.
Administrator
only.
Administrator
only.
Administrator
only.
SCALANCE X-300 / X-400