Siemens SCALANCE X-300 Configuration Manual page 283

Creating a new IP subnet
You can create a new subnet by clicking the "New Entry" button in the "Router Subnets"
dialog. You make the settings for the subnet in the "Router Subnet Configuration" menu.
Figure 4-129 Router Subnets Configuration
VLAN ID
Here, enter the ID of the VLAN (VID see the section "Current VLAN Configuration menu
item") via which packets of this IP subnet will be transmitted (range of values of the ID: 1 to
4094).
Note
The agent VLAN ID must not be used again. All other IDs can be used more than once.
IP Address
Enter the IP address of the IP subnet. IP addresses must not be used more than once.
Note
By appending the "/" character and a number between 1 and 30, the subnet can also be
defined at the same time.
Subnet Mask
Here, enter the subnet mask of the IP subnet you are creating. The subnet mask must be
made up of a left-justified bit field of ones.
Name
Here, enter the name of the subnet (this has no effect on the functionality).
SCALANCE X-300 / X-400
Configuration Manual, 10/2014, C79000-G8976-C187-22
Configuration using Web Based Management and Command Line Interface
4.7 The Router menu (SCALANCE X414-3E)
283