Siemens SCALANCE X-300 Configuration Manual page 381

● Ring redundancy disabled.
● (R)STP protocol enabled.
● (R)STP protocol disabled.
● Disabled (R)STP because ring redundancy is enabled.
● DIP settings taken from C-PLUG.
RM=<ON|OFF>, STBY=<ON|OFF>, R1=<ON|OFF>, R2=<ON|OFF>
● (R)STP topology change detected while (R)STP is off. Aging time will be reduced to
<time in s> sec for at least <time in s> sec.
● Set aging time back to original value <time in s> sec.
● No connection to SNTP server. Server IP address <IP address>.
● Connected to SNTP server. Server IP address <IP address>.
● Enabled link status monitoring on ring ports.
● Changed port VLAN ID of the ring ports to 1.
● Disabled GVRP because ring redundancy is enabled.
● Disabled GMRP because ring redundancy is enabled.
● Disabled mirroring because monitor port is ring port.
● (Re)enabled ring ports (because disabled by user).
● Disabled port lock on ring ports.
● Warning: ring ports have different static VLAN configuration.
● Warning: ring ports have different VLAN port configuration.
● Warning: ring ports have different static multicast configuration.
● Warning: ring ports have different load limits configuration.
● Enter fault state: port <port number> enabled for link status monitoring and link down.
● Leave fault state: port <port number> disabled for link status monitoring.
● Enter fault state: power line <ID of power supply> enabled for power monitoring and
power down.
● Leave fault state: power line <ID of power supply> disabled for power monitoring.
● <CLI | WBM | SSH>: Authentication failure.
● Warning: OSPF consumed too much memory and is shut down.
● Duplicate IP address <IP address> sent from <MAC address>
● IN <number of the digital input> (<name of the input>) <high | low>
● VRRP: Virtual Router <number of the routers> on VLAN <VLAN-ID> transitioned to
<Master | Backup | Disabled | Initialize | Invalid> state.
● PNIO configuration invalid, conflict with standby.
● PNIO configuration invalid, conflict with HRP.
● PNIO configuration invalid, conflict in MRP ring ports: <cause of conflict>
SCALANCE X-300 / X-400
Configuration Manual, 10/2014, C79000-G8976-C187-22
D.1 Error messages of the SCALANCE X300 / X400
Appendix D
381