Siemens SCALANCE X-300 Configuration Manual page 92

Configuration using Web Based Management and Command Line Interface
4.4 The Agent menu
allvlans
bootp [E|D]
dhcp [E|D]
mail [E|D]
ftp [E|D]
dcp [D|RO|RW]
telnet [E|D]
rmon [E|D]
macl [E|D]
sntp [E|D]
siclock
ntp [E|D]
ptp [E|D]
ping [-c number]
[-s length]
<IP address>
ssh [E|D]
92
Command
Specifies whether or not the agent
functionalities are available via all
VLANs or only via the agent VLAN.
Enables / disables BOOTP.
Enables / disables DHCP.
Enables/disables E-mail functionality.
Enables / disables FTP.
Enables / disables DCP
D
•
Disabled
RO
•
Read-only
RW
•
Read-write
Enables / disables TELNET.
Enables / disables remote monitoring.
Enables/disables Management Access
Control List.
Enables / disables SNTP.
Enables/disables time synchronization
with the SIMATIC time protocol.
Enables / disables NTP.
Enables / disables PTP.
Sends a number of packets to the
specified IP address. If the parameters
for number and length are omitted, an
IE switch sends ten packets each with
a length of 128 bytes.
Example:
ping -c 5 -s 256 192.168.1.1
Five packets with a length of 256 bytes
are sent to IP address 192.168.1.1.
Enables / disables SSH.
Description
Configuration Manual, 10/2014, C79000-G8976-C187-22
Comment
Administrator only.
Default value: Disabled
Administrator only.
Default value: Disabled
Administrator only.
Default value: Enabled.
Administrator only.
Default value: Disabled.
Administrator only.
Default value: Enabled
Administrator only.
Default value: Read Write
Administrator only.
Default value: Enabled.
Administrator only.
Default value: Disabled
Administrator only.
Administrator only.
Default value: Disabled
Administrator only.
Default value: Enabled
Administrator only.
Default value: Disabled
Administrator only.
Default value: Disabled
-
Administrator only.
Default value: Enabled
SCALANCE X-300 / X-400