Configuration using Web Based Management and Command Line Interface
4.5 The Switch menu
Slot / Port
You have the option of adding specific ports to the link aggregation or removing them from it.
You can only modify ports that are not members of another link aggregation.
The meaning is as follows:
● M (black): The port is a member of the aggregation.
● M (blue): The port is a member of the aggregation and is its master port.
Changing the master port
To change the master port, follow the steps below:
1. Click on the original master port (blue M) - the marking disappears. If you want to keep
the port in the aggregation, click on it a second time (black M)
2. Click on the new master port until a blue M appears.
Syntax of the Command Line Interface
Current Link Aggregation - CLI\SWITCH\LAG>
info
frmdistr [mode]
add <masterport>
150
Command
Shows the current settings of the link aggregation
group (actual status).
Sets the type of distribution of packets on the
individual links of an aggregation.
The following modes exist for X414:
srcmac
•
source MAC address
dstmac
•
destination MAC address
mac
•
source and dest. MAC address
srcip
•
source IP address
dstip
•
destination IP address
ip
•
source and dest. IP address)
The following modes exist for X408/X-300:
hash
•
source and dest. MAC address hash
xor
•
source and dest. MAC address Xor
Creates a new link aggregation with the specified
master port
Description
Configuration Manual, 10/2014, C79000-G8976-C187-22
Comment
-
Administrator only.
Administrator only.
SCALANCE X-300 / X-400