Siemens SCALANCE X-300 Configuration Manual page 291

Creating a new RIPv2 interface
You can create a new interface by clicking the "New Entry" button in the "RIP Interfaces"
dialog. This opens the following dialog.
Figure 4-134 RIPv2 Interface Configuration
IP Address
Here, you enter the IP address of the interface on which RIP will be configured. This IP
address must already be configured as an IP subnet.
Send-Updates
Here, you select how the RIP updates will be sent. The update packets contain the routing
table of the local system. The following are available:
● no send:
Do not send updates
● RIPv1:
Send RIPv1 updates according to the rules of RFC 1058
● RIPv1-compat:
Send RIPv2 updates according to the rules of RFC 1058 as broadcasts
● RIPv2:
Send RIPv2 updates as multicast
● The values "RIPv1 demand" and "RIPv2 demand" are required only for WAN interfaces.
In this case, RIP the packets are sent only as a response to an explicit query.
Note
If there are no RIPv1 devices whatsoever in your network, you should set "RIPv2".
SCALANCE X-300 / X-400
Configuration Manual, 10/2014, C79000-G8976-C187-22
Configuration using Web Based Management and Command Line Interface
4.7 The Router menu (SCALANCE X414-3E)
291