Siemens SCALANCE X-300 Configuration Manual page 246

Configuration using Web Based Management and Command Line Interface
4.5 The Switch menu
CLI\SWITCH\1588\TC>
delaymec [E2E|P2P]
domainnb [number]
vlanid [VID]
vlanprio [<0..7>]
PORTS
CLI\SWITCH\1588\TC\PORTS>
tcport <E|D> [ports]
transmec <IPv4|ETH>
[ports]
246
Command
Specifies the delay mechanism for the device:
E2E
P2P
Specifies the identification number for the time
domain. Only devices within the domain are
synchronized, PTP messages with a different
domain number are discarded.
Specifies the VLAN ID.
Specifies the VLAN priority.
Opens the PORTS menu.
Command
Enables/disables the specified ports.
A range of ports is specified with a hyphen.
Several ports are separated by blanks or
commas.
Specifies the protocol for transferring the PTP
messages. This protocol must also be support-
ed by the communications partner of the port.
IPv4
ETH
Description
End-to-end
(delay request response mechanism
will be used).
Peer-to-peer
(peer delay mechanism will be used).
Description
Internet Protocol (Layer 3)
Ethernet (Layer 2)
Configuration Manual, 10/2014, C79000-G8976-C187-22
Comment
Administrator only.
Administrator only.
Administrator only.
Administrator only.
Administrator only.
Comment
Administrator only.
Administrator only.
SCALANCE X-300 / X-400