Pulse Measurement Settings; How To Select Pulse Measurement Mode; Measurement Selection; Frequency / Time - Keysight N9912A User Manual

Pulse Measurements Mode – Option 330

Pulse Measurement Settings

Pulse Measurement Settings
Select Pulse Measurement Mode before making any setting in this section.

How to select Pulse Measurement Mode

— Press Mode.
— Then
— Then

Measurement Selection

The pulse measurement results are presented as either a traditional power
meter display or as a trace graph.
How to select the Measurement
— Press Measure 1.
— Then choose from the following:

Frequency / Time

How to set Frequency
— Press Freq/Dist.
— Then choose from the following:
13-4
More if your FieldFox contains more than five measurement modes.
Pulse Measurements.
— Average Average power (Meter display)
— Peak Peak power (Meter display)
— Pk to Avg Displays the difference between the above two
measurements (Meter display)
— Trace Graph (default) The primary trace (Tr 1) plots pulse data in
amplitude versus time. Optionally, you can enable a secondary
'zoom' trace. Learn how in
— When a 'Meter display' measurement is selected, the following Pulse
Measurement Mode settings are identical to the standard USB Power
Meter Mode settings.
— Learn how to set "Scale" on page
— Learn how to set "Relative and Offset Power Measurements" on
page 11-6.
— Learn how to set "Display Units" on page
— Learn how to set "Limits" on page
"Zoom Window" on page
13-6.
11-6.
11-8.
Keysight N9912-90001 User's Guide
13-5.