Marker Table - Keysight N9912A User Manual

Data Analysis Features
All about Markers
How to Create a Delta Marker
— Create a Normal marker and move it to the reference position.
— Press Delta. The marker becomes the reference marker and fixed in its
X-Axis position.
— Move the
rotary knob.
— Press Enter when finished.
How to move the Reference marker
— Press
— Move the marker to the new position.
— Then press
Fix the position of the Reference marker (SA Mode ONLY)
In SA mode, the reference marker can be fixed at the Y-axis position of the data
trace when the marker was created, or it can 'float' with each sweep at the
Y-axis position of the data trace. In CAT and NA mode, the reference marker
always floats with the data trace. This setting applies to all SA markers.
— Create a Delta marker.
— From the Mrk ->/Tools menu, press More, then
Delta Ref

Marker Table

The Marker Table can be displayed at the bottom of the FieldFox screen. It can
display information for up to 6 markers in a full-width window, and up to 3
markers for a half-width window (NA mode). The marker table "squeezes" the
graticule area when activated.
How to display the Marker table
— Press Marker.
— Then
16- 4
Delta marker using the numeric keypad, the
Delta to turn the Delta marker OFF.
Delta again, to turn the Delta marker back ON.
Fixed.
— OFF – The reference marker floats at the data trace Y-axis position.
— ON – The reference marker is fixed at the Y-axis position of the data
trace when the marker was created (default SA mode).
Marker Table On Off.
arrows, or the
Marker Properties, then
Keysight N9912-90001 User's Guide