Quick Settings - Keysight N9912A User Manual

NA (Network Analyzer) Mode
NA Mode Settings
— By default, a marker is created on ALL traces. However, they can be created
individually by disabling Coupled Markers. Learn more in
(NA Mode)" on page
How to select a multi-trace configuration
— Press Trace 6.
— Then
— Then choose from the following:
The default measurements depend on the options that are installed
How to activate a trace in order to change a setting
— Use the
— Press Trace 6 then select
that are shown can be activated.
How to maximize the viewing of the active trace
— Press System 7.
— Then
— Press any key to return to the standard display.

Quick Settings

Both CAT and NA Modes allow you to view and change most relevant settings
from a single location. All of these settings are discussed in this chapter and,
unless otherwise noted, ALL of these settings can also be made using the
standard softkey menus.
Keysight N9912-90001 User's Guide
16-5.
Num of Traces.
x1
x2
x2H
x3H
x3
x4H
arrows OR
Trace
Full Screen.
1 trace standard configuration
2 traces overlayed on a single graticule
2 traces on separate graticules
3 traces on separate graticules
3 traces overlayed on a single graticule
4 traces on separate graticules
1, Trace 2, Trace 3, or
"Coupled Markers
Trace 4, Only traces
5- 5