Channel Selection - Keysight N9912A User Manual

SA (Spectrum Analyzer) Mode
SA Mode Settings
— Then select the *.csv file using the
Enter.
— Custom Radio Standards can be removed from the FieldFox by selecting
Measure 1 then
— Then select the *.csv file to delete using the
press Enter.
To overwrite a custom standard that is already uploaded to the FieldFox,
you must first delete the *.csv file from the FieldFox, then re-upload the file
that contains the standard. A predefined internal standard (such as GSM
450) can NOT be deleted from the FieldFox.

Channel Selection

After a Radio Standard has been selected, the frequency range can be
changed by selecting channel numbers rather than frequency. Once enabled,
the channel number is appended to the X-axis frequency range.
How to Enable Channel selection
— Press Freq/Dist.
— Then More.
— Then
How to change the Channel Number of the Measurement
With Unit =
of the selected Radio Standard.
— Press Freq/Dist.
— Then choose from the following:
Keysight N9912-90001 User's Guide
Rad io Standard
Unit Freq Chan.
Chan the FieldFox will NOT allow you to specify channels outside
— Center Channel Places the center frequency of the specified channel
in the middle of the X-axis.
— Start Channel Places the lowest frequency of the specified channel
at the beginning of the X-axis.
— Stop Channel Places the highest frequency of the specified channel
at the end of the X-axis.
— Freq Span Changes the span of frequencies while the center
frequency remains unchanged.
— Follow each of the above settings by entering a value using the
numeric keypad or the rotary knob.
arrows or rotary knob and press
then Delete Rad io Standard.
arrows or rotary knob and
8- 7