Run/Hold; How To Perform A Single Sweep While In Hold - Keysight N9912A User Manual

System Settings

Run/Hold

See Also:
Run/Hold
The Run/Hold key determines whether the FieldFox sweeps continuously or
does NOT sweep, but holds the display results of the last sweep that was
performed.
Use Hold to conserve battery power or to allow you to save or analyze the
results of a specific measurement sweep.
The current sweep mode is shown on the screen as:
—
—
—

How to perform a single sweep while in Hold

— Press Sweep 3.
— Then choose one of the following:
18- 2
"Security Level" on page 18-16
"Date and Time, Format, and Time Zone Settings" on page 18-16
"LAN Settings" on page 18-18
"Power ON" on page 18-19
"FieldFox Package Installer (N9912A units with serial number
prefixes ≥5607 Only)" on page 18-20
"Service Diagnostics" on page 18-22
"System Information" on page 18-22
"Event Log" on page 18-22
"Battery" on page 18-22
"Internal Temperatures" on page 18-23
"Erase User Data" on page 18-23
"Install the Lithium-Ion Battery" on page 2-2
"FieldFox High Temperature Protection" on page 2-4
Continuous
Hold
is displayed while a single sweep occurs.
— Single Automatically sets Continuous OFF (Hold) and causes
FieldFox to make ONE measurement sweep, then hold for the next
Single key press.
Keysight N9912-90001 User's Guide