Power On - Keysight N9912A User Manual

System Settings
System Configuration
— Then LAN.
— Use the
— Hostname Change the name that can be used to address the FieldFox if
your server supports this feature. The default hostname is generated
automatically.
— Obtain IP Choose from:
For all FieldFoxes with firmware ≤A.08.25 and ≤A.09.50 FW, when using
Static IP addresses:
— Static Subnet Mask - Enter the Subnet Mask – including periods - in the
format nnn.nnn.nnn.nnn
— Static Gateway - Enter the Static Gateway – including periods - in the
format nnn.nnn.nnn.nnn
— Static DNS - Enter the Static DNS – including periods - in the format
nnn.nnn.nnn.nnn
— Apply Settings Choose from:
To make the LAN settings persist after power up, toggle Apply Settings to
Now then back to Power Up. You should see a message indicating that the
LAN config file was saved.
— Press

Power ON

When the FieldFox is without a power source, this setting allows the FieldFox
to power ON as soon as a charged battery or the DC Adapter is inserted
without pressing the power button.
Keysight N9912-90001 User's Guide
arrows to select one of the following, then press
—DHCP - IP Address is assigned dynamically. If your server supports this
feature, the IP Address for the FieldFox is assigned each time it is
started.
—Static - Set the IP Address manually. The Address remains until you
change it.
— Static IP Address - Enter the IP Address – including periods - in the
format nnn.nnn.nnn.nnn
— Either a valid Static Gateway is required or 0.0.0.0.
— Either a valid Static DNS is required or 0.0.0.0. (If entry is available.)
—Power Up The above settings take effect when the FieldFox is started.
—Now The above settings take effect immediately.
Done Ed it when finished.
Ed it.
18- 19