Limit Options; How To Save And Recall Limits - Keysight N9912A User Manual

Data Analysis Features
All about Limit Lines

Limit Options

How to set Limit Options
— Press
— Then Options.
— Then choose from the following:

How to Save and Recall Limits

In addition to saving and recalling limits with an *.sta file, limit lines can also be
saved and then recalled independent of the current mode or measurement.
Use this feature to recall and apply existing limit lines to measurements with
different settings or even a different frequency range.
Limit line files can be loaded into the FieldFox Data Link Software. Learn how in
the help file that is included in the Data Link software.
— Press Save/Recall then
flash drive) to be used for the Save or Recall. Learn more in
and Select Device" on page
Keysight N9912-90001 User's Guide
Exit if the limit table is visible.
— Beep
——On Pass Audible beep sounds when a sweep passes.
——On Fail Audible beep sounds when a sweep fails.
——Off No audible beep sounds.
— Warning On Off Shows Pass or Fail indication on the display with
each sweep. Data points that fail are highlighted.
— Limit Type Then Fixed or Relative.
— Offset Shifts the limit line up or down. Enter an offset value using the
rotary knob, the
keys.
——Enter a positive offset to shift the limit line UP, usually used
with UPPER limits.
——Enter a negative offset to shift the limit line DOWN, usually
used with LOWER limits.
— Margin Shifts the limit line up or down like an offset, but only
virtually. The limit line does NOT appear to move. Enter a Margin
value using the rotary knob, the
with the number keys.
Enter a positive margin to virtually shift the limit line UP.
Enter a negative margin to virtually shift the limit line DOWN.
Device
arrows, or by entering a value with the number
arrows, or by entering a value
to set the Device (Internal, SD card, or USB
17-5.
"Set File Type
16- 17