SA (Spectrum Analyzer) Mode
SA Mode Settings
— Then choose from:
Trace Display States
In SA Mode you can display up to four of the following types of trace states. All
SA settings are applied to all displayed traces.
A color-coded legend for displayed traces is visible in the left pane of the SA
mode screen:
W = Clear/Write; M = MaxHold; m = MinHold; A = Average; V = View
How to display the Trace States
— Press Trace 6.
— Then
its state. Traces are displayed in the following colors:
— Then
— Then choose from the following Trace States:
— Press
(Clear/Write); all other traces (Blank).
Trace 4 data WILL be overwritten by the FieldFox when using the
Independent Source Normalize feature
page
Strength Measurements" on page
8- 28
101 | 201 | 401 | 601 | 801 |
Trace 1,2,3,4
repeatedly to select a trace number to display or change
—Trace 1 – Yellow
—Trace 3 – Orange
State [current setting]
—
Clr /Wr
(Clear/Write) Displays the actual measured data for each
sweep.
—
MaxHold
Displays the maximum response of the input signal at each
data point over multiple sweeps. See also Average Count in
Count" on page
8-29.
—
MinHold
Displays the minimum response of the input signal at each
data point over multiple sweeps. See also Average Count in
Count" on page
8-29.
—
Average
Each data point is averaged over multiple sweeps as set by
the Average Count setting. Learn more in
page
8-29.
—
View
Displays and then holds the last complete measurement trace
on the screen. This is similar to storing a trace in memory.
—
Blank
Displays no trace.
Default All
to return all traces to their default settings: Trace 1
8-18) or using Field Strength antenna or cable corrections
1001.
Trace 2 – Blue
Trace 4 – Green
"Average Count" on
("Independent Source" on
8-12).
Keysight N9912-90001 User's Guide
"Average
"Average
("Field