Keysight N9912A User Manual page 113

SA (Spectrum Analyzer) Mode
SA Mode Settings
— Follow each of these by entering a value using the numeric keypad, the
— When using the
arrows is based on the current span. This can be changed in SA Mode. See
How to change frequency step size below.
— After using the keypad, select a multiplier key. Learn more in
Abbreviations" on page
Two more ways to change the frequency range
— Press Freq/Dist
— Then choose from the following:
How to change frequency step size
When using the
of the frequency step can be changed.
— Press Freq/Dist
— Then
— Then
Keysight N9912-90001 User's Guide
— Start and Stop frequencies. Start is the beginning of the X-axis and
Stop is the end of the X-axis. When the Start and Stop frequencies
are entered, then the X-axis annotation on the screen shows the Start
and Stop frequencies.
arrows, or the rotary knob.
arrows, press Enter. The increment setting of the
2-14.
— Zero/Last Span Each key press toggles the frequency span between
0 Hz and the last specified frequency span. Learn more about Zero
Span in "Zero Span Measurements" on page
— More
— Then Full Span Selects the entire frequency span of the FieldFox. The
Center frequency is set automatically.
arrows to change any of the frequency settings, the size
More
CF Step Auto Man
— Auto Each press of the
value by 1/10th (one division) of the current frequency span. Note: To
change this setting from Manual to Auto, press CF Step twice.
— Manual Type a step size value using the numeric keypad, then select
a multiplier key. Learn more in
page 2-14.
8-23.
arrows increments or decrements the
"Multiplier Abbreviations" on
"Multiplier
8- 5