Quick Settings Table - Keysight N9912A User Manual

CAT (Cable and Antenna Test) Mode
CAT Mode Settings
— Cable Loss (1-Port)
a transmission line. Learn more on
— Insertion Loss (2-Port)
measurement that accurately displays the loss through a cable or other
device in dB. Both ends of the cable must be connected to the FieldFox. NO
phase information is included in this measurement. Learn more at
Insertion Loss Measurements" on page
— DTF (Lin)
— TDR (Lin rho)
without reflections shows as 0 (zero). Maximum reflections from an open or
short show as 1.
— TDR (ohm)
— TDR & DTF

Quick Settings Table

Both CAT and NA Modes allow you to view and change most relevant settings
from a single location. All of these settings are discussed in this chapter and,
unless otherwise noted, ALL of these settings can also be made using the
standard softkey menus.
How to view and change Quick Settings
— Press Meas Setup 4.
— Then Settings.
— Press
are NOT available, then all available settings fit on one page.
— To change a setting:
— Press
the trace window. The Dock Window setting persists through a Preset.
Choose from the following
3- 4
1-port reflection measurement that displays the loss of
(Option 110 ONLY) 2-port transmission
Distance to Fault in Linear format.
The Y-axis of the display is linear, real, unitless values. A trace
The Y-axis of the display is impedance (ohms).
TDR and DTF are displayed.
Next Page and Previous Page
— Use the arrows to highlight a setting.
— Then press Ed it. The current setting changes to yellow.
— Some settings require you to press a softkey to change the value.
Otherwise, use the numeric keypad,
change the value.
— When finished changing a value, press
Dock Window to relocate the Settings table to a position relative to
— Full (Default setting) Only the Settings table is shown on the screen.
The trace window is temporarily not shown
— Left The Settings table is shown to the left of the trace window
page 3-12.
3-14.
to view all settings. If these softkeys
arrows, or rotary knob to
Done Edit.
Keysight N9912-90001 User's Guide
"2-Port