Fieldfox Package Installer (N9912A Units With Serial Number Prefixes ≥5607 Only) - Keysight N9912A User Manual

System Settings
System Configuration
How to set Power ON
— Press System 7.
— Then
— Then
— Then choose from the following:
FieldFox Package Installer (
prefixes ≥5607 Only
The FieldFox Package Installer enables you to download new versions of
firmware from either a USB memory or SD Card. Additionally, the Utility softkey
enables you to backup user files or restore user files.
How to run the Installer
Before running the Installer to update your firmware, you might want to
back up your user data. Refer to
— Press System 7.
— Then
— Then
— Then
— Then
— The Installer software opens after a couple of seconds.
If no files are displayed, verify that a USB memory or SD Card is installed
and press
— Then the
install.
— Press
— "Current Step Progress:" bar and a "Total Progress:" bar are
displayed along with this message: "Copying package. Do not
remove install media."
18- 20
System Configuration.
Power ON.
— Auto The FieldFox will power ON when a charged battery or the DC
Adapter is inserted.
— Manual The FieldFox will power ON only when the power button is
pressed.
N9912A units with serial number
)
System Configuration.
More
Firmware Update
Start Installer
Refresh List.
arrows or the knob to scroll to the firmware you want to
Start Install
"How to restore files" on page
Keysight N9912-90001 User's Guide
18-21.