Unicast; Filtering - Siemens SCALANCE XB-200 Configuration Manual

Steps in configuration
Activating fiber monitoring
Follow the steps below to activate the monitoring of a port:
1. Select the appropriate check box in the "Status" column.
2. For your setup, enter practical values value at which you want to be informed of
deterioration of the received power and the power loss of the connection.
3. Click the "Set Values" button.
Deactivating fiber monitoring
Follow the steps below to deactivate the monitoring of a port:
1. Deselect the appropriate check box in the "Status" column.
2. Click the "Set Values" button.
5.5.14

Unicast

5.5.14.1

Filtering

Address filtering
This table shows the source addresses of unicast address frames entered statically by the
user during parameter assignment.
On this page, you also define the static unicast filters.
Dependency on the "Base bridge mode"
The displayed boxes depend on which "Base bridge mode" is set. If you change the "Base
bridge mode" the existing entries are lost.
Figure 5-7
SCALANCE XB-200/XC-200/XP-200 Web Based Management
Configuration Manual, 07/2016, C79000-G8976-C360-04
Base bridge mode: 802.1Q VLAN Bridge
Configuring with Web Based Management
5.5 The "Layer 2" menu
219