Siemens SCALANCE XB-200 Configuration Manual page 179

Description of the displayed values
Table 1 has the following columns:
● 1st column
Shows that the settings are valid for all ports.
● Limit Ingress Unicast(DLF) / Limit Ingress Broadcast / Limit Ingress Multicast
Select the required setting in the drop-down list.
– Enabled: Enables the function.
– Disabled: Disables the function
– No Change: The setting in table 2 remains unchanged
● Total Ingress Rate kb/s
Specify the data rate for all incoming frames. If "No Change" is entered, the entry in table
2 remains unchanged
● Egress Rate kb/s
Specify the data rate for all outgoing frames. If "No Change" is entered, the entry in table
2 remains unchanged
● Copy to table
If you click the button, the settings are adopted for all ports of table 2.
Table 2 has the following columns:
● Port
Shows all available ports. The port is made up of the module number and the port
number, for example port 0.1 is module 0, port 1.
● Limit Ingress Unicast(DLF)
Enable or disable the data rate for limiting incoming unicast frames with an unresolvable
address (Destination Lookup Failure).
● Limit Ingress Broadcast
Enable or disable the data rate for limiting incoming broadcast frames.
● Limit Ingress Multicast
Enable or disable the data rate for limiting incoming multicast frames.
● Total Ingress Rate kb/s
Specify the data rate for all incoming frames.
● Egress Rate kb/s
Specify the data rate for all outgoing frames.
Note
Rounding of the values, deviation from desired value
When you input, note that the WBM rounds to correct values.
If values are configured for Total Ingress Rate and Egress Rate, the actual values in
operation can deviate slightly from the set values.
SCALANCE XB-200/XC-200/XP-200 Web Based Management
Configuration Manual, 07/2016, C79000-G8976-C360-04
Configuring with Web Based Management
5.5 The "Layer 2" menu
179