Siemens SCALANCE XB-200 Configuration Manual page 103

Table 2 has the following columns:
● Event
The column contains the following values:
– Cold/Warm Start
– Link Change
– Authentication Failure
– RMON Alarm
– Power Change
– RM State Change
– Spanning Tree Change
– Fault State Change
– Standby State Change
– Loop detection
– 802.1X Port Authentication State Change
– PoE State Change
– Temperature Alarm
● E-mail
The device sends an e-mail. This is only possible if the SMTP server is set up and the
"SMTP client" function is enabled.
SCALANCE XB-200/XC-200/XP-200 Web Based Management
Configuration Manual, 07/2016, C79000-G8976-C360-04
The device was turned on or restarted by the user. In the error memory of the device a
new entry is generated with the type of restart performed.
This event occurs only when the port status is monitored and has changed, see
"System > Fault Monitoring > Link Change".
This event occurs when access is attempted with an incorrect password.
An alarm or event has occurred relating to the remote monitoring of the system.
This event occurs only when power supply lines 1 and 2 are monitored. It indicates
that there was a change to line 1 or line 2. See "System > Fault Monitoring > Power
Supply".
The redundancy manager has recognized an interruption or restoration of the ring and
has switched the line over or back.
The spanning tree topology has changed.
The fault status has changed. The fault state can relate to the activated port
monitoring, the response of the signaling contact or the power supply monitoring.
A device with an established standby connection (master or slave) has activated or
deactivated the link to the other ring (standby port). The data traffic was redirected
from one Ethernet connection (standby port of the master) to another Ethernet
connection (standby port of the slave).
A loop was detected in the network segment.
This event occurs with 802.1X authentications.
The status of PoE has changed.
The temperature has fallen below or exceeded a certain limit.
Configuring with Web Based Management
5.4 The "System" menu
103