Siemens SCALANCE XB-200 Configuration Manual page 96

Configuring with Web Based Management
5.4 The "System" menu
Steps in configuration
Uploading files using HTTP
1. Start the upload function by clicking the one of the "Load" buttons.
A dialog for uploading a file opens.
2. Select the required file and confirm the upload.
The file is uploaded.
3. If a restart is necessary, a message to this effect will be output. Click the "OK" button and
a restart will follow. If you click the "Abort" button, there is no device restart. The changes
only take effect after a restart.
Downloading files using HTTP
1. Start the download by clicking the one of the "Save" buttons.
2. Select a storage location and a name for the file.
3. Save the file.
The file is downloaded and saved.
Deleting files using HTTP
1. Start the delete function by clicking the one of the "Delete" buttons.
The file is deleted.
Reusing configuration data
If several identical devices are to receive the same configuration and the IP addresses are
assigned using DHCP, the effort for reconfiguration can be reduced by saving and reading in
the configuration data.
Follow the steps below to reuse configuration data:
1. Save the configuration data of a configured device on your PC.
2. Load this configuration file on all other devices you want to configure in this way.
3. If individual settings are necessary for specific devices, these must be made online on the
relevant device.
Note
Configuration data has a checksum. If you change the data, you can no longer upload it to
the IE switch.
96
SCALANCE XB-200/XC-200/XP-200 Web Based Management
Configuration Manual, 07/2016, C79000-G8976-C360-04