Siemens SCALANCE XB-200 Configuration Manual page 149

● Port Type
Select the type of port from the drop-down list.
– Switch Port VLAN Hybrid
– Switch Port VLAN Trunk
● OperState
Displays the current operational status. The operational status depends on the configured
"Status" and the "Link". The available options are as follows:
– up
– down
– not present
● Link
Shows the connection status to the network. The available options are as follows:
– up
– down
Changing the port configuration
Click the appropriate box to change the configuration.
Note
Optical ports only work with the full duplex mode and at maximum transmission rate. As a
result, the following settings cannot be made for optical ports:
• Automatic configuration
• Transmission speed
• Transmission technique
SCALANCE XB-200/XC-200/XP-200 Web Based Management
Configuration Manual, 07/2016, C79000-G8976-C360-04
The port sends tagged and untagged frames. It is not automatically a member of a
VLAN.
The port only sends tagged frames and is automatically a member of all VLANs.
You have configured the status "enabled" for the port and the port has a valid
connection to the network.
You have configured the status "disabled" or "Link down" for the port or the port has
no connection.
With modular devices, this status is displayed when, for example, no media module is
inserted.
The port has a valid link to the network, a link integrity signal is being received.
The link is down, for example because the connected device is turned off.
Configuring with Web Based Management
5.4 The "System" menu
149