Port Range - Siemens SCALANCE XB-200 Configuration Manual

Creating a DHCP pool
1. Click the "Create" button.
2. Select a VLAN IP interface.
3. Enter the subnet, the lower and the upper IPv4 address.
4. Enter the lease time.
5. Click the "Set Values" button.
In the "Port Range" tab, all ports are enabled that currently belong to the selected VLAN.
The standard options for the pool are created in the "DHCP Options" tab.
6. Make the settings you require for the pool in the DHCP tabs.
7. Select the "Enable" check box on this tab.
Deleting a DHCP pool
Note
You can only delete entries that are not enabled.
1. Enable the "Select" check box in the row to be deleted.
Repeat this for all entries you want to delete.
2. Click the "Delete" button.
The entry is deleted.
5.4.8.3

Port Range

On this page, you define the ports via which the IPv4 addresses of an address band are
assigned.
After you have created an IPv4 address band in the "DHCP Server" tab, a new line is
created in this tab and all ports selected that are currently located in the corresponding
VLAN. If you add ports to the VLAN later, the ports are not automatically enabled in this tab.
SCALANCE XB-200/XC-200/XP-200 Web Based Management
Configuration Manual, 07/2016, C79000-G8976-C360-04
Configuring with Web Based Management
5.4 The "System" menu
111