Siemens SCALANCE XB-200 Configuration Manual page 48

Configuring with Web Based Management
5.3 The "Information" menu
● PROFINET AR Status
Shows the PROFINET application relation status.
– Online
– Offline
● Power Supply 1 / Power Supply 2
– Up
– Down:
● PLUG Configuration
Shows the status of the configuration data on the PLUG, refer to the section "System >
PLUG > Configuration".
● Fault Status
Shows the fault status of the device.
Buttons you require often
The pages of the WBM contain the following standard buttons:
● Refresh the display with "Refresh"
Web Based Management pages that display current parameters have a "Refresh" button
at the lower edge of the page. Click this button to request up-to-date information from the
device for the current page.
Note
If you click the "Refresh" button, before you have transferred your configuration changes
to the device using the "Set Values" button, your changes will be deleted and the
previous configuration will be loaded from the device and displayed here.
● Save entries with "Set Values"
Pages in which you can make configuration settings have a "Set Values" button at the
lower edge. The button only becomes active if you change at least one value on the
page. Click this button to save the configuration data you have entered on the device.
Once you have saved, the button becomes inactive again.
Note
Changing configuration data is possible only with the "admin" role.
48
There is a connection to a PROFINET controller. The PROFINET controller has
downloaded its configuration data to the device. The device can send status data to
the PROFINET controller.
In this status, the parameters set via the PROFINET controller cannot be configured
on the device.
There is no connection to a PROFINET controller.
Power supply 1 or 2 is applied
Power supply 1 or 2 is not applied or is below the permitted voltage.
SCALANCE XB-200/XC-200/XP-200 Web Based Management
Configuration Manual, 07/2016, C79000-G8976-C360-04