Table of Contents
Advertisement
•
Preventing a Source from Registering with the RP
•
Preventing a PIM Router from Processing a Join
Limiting the Number of Multicast Routes
When the total number of multicast routes on a system limit is reached, Dell Networking OS does not process
any IGMP or multicast listener discovery protocol (MLD) joins to PIM — though it still processes leave
messages — until the number of entries decreases below 95% of the limit.
When the limit falls below 95% after hitting the maximum, the system begins relearning route entries through
IGMP, MLD, and MSDP.
•
If the limit is increased after it is reached, join subsequent join requests are accepted. In this case,
increase the limit by at least 10% for IGMP and MLD to resume.
•
If the limit is decreased after it is reached, Dell Networking OS does not clear the existing sessions.
Entries are cleared after a timeout (you may also clear entries using clear ip mroute).
NOTE:
Dell Networking OS waits at least 30 seconds between stopping and starting IGMP join processing.
You may experience this delay when manipulating the limit after it is reached.
When the multicast route limit is reached, Dell Networking OS displays the following:
3w1d13h: %RPM0-P:RP2 %PIM-3-PIM_TIB_LIMIT: PIM TIB limit reached. No new
routes will
be learnt until TIB level falls below low watermark.
3w1d13h: %RPM0-P:RP2 %PIM-3-PIM_TIB_LIMIT: PIM TIB below low watermark.
Route learning
will begin.
To limit the number of multicast routes, use the following command.
•
Limit the total number of multicast routes on the system.
CONFIGURATION mode
ip multicast-limit
The range if from 1 to 16000.
The default is 4000.
NOTE:
The IN-L3-McastFib CAM partition is used to store multicast routes and is a separate hardware
limit that exists per port-pipe. Any software-configured limit may supersede by this hardware space
limitation. The opposite is also true, the CAM partition might not be exhausted at the time the system-
wide route limit the ip multicast-limit command sets is reached.
Preventing a Host from Joining a Group
You can prevent a host from joining a particular group by blocking specific IGMP reports. Create an extended
access list containing the permissible source-group pairs.
NOTE:
For rules in IGMP access lists, source is the multicast source, not the source of the IGMP packet.
For IGMPv2, use the keyword any for source (as shown in the following example), because IGMPv2 hosts
do not know in advance who the source is for the group in which they are interested.
To apply the access list, use the following command.
•
Apply the access list.
INTERFACE mode
Multicast Features
721
Advertisement
Table of Contents
Troubleshooting
