Dell C9000 Series Networking Configuration Manual page 381

-- Temperature Limits (deg C)
---------------------------------------------------------------------------
Minor Off
linecard0
---------------------------------------------------------------------------
Minor Off
RPM0
---------------------------------------------------------------------------
Minor Off
PEid100/Stack0
To display current temperature of line sensors, use the show environment thermal-sensors command.
Minor threshold crossings do not cause alarms, but are used to trigger increases in the speed of the system
fans as needed to keep the component temperature within the desired range.
Dell#show environment thermal-sensor
-- Thermal Sensor Readings (deg C)
Slot 0 1
----------------------------------------------------------------
47 47
To get the current sensor temperature of RPM, use the show rpm rpm-id.
In the following example, 29C is the CP card's temperature in RPM. 52C is LP card's sensor temperature in the
RPM.
Dell#show rpm 1
-- RPM card 1 --
Status : active
Next Boot : online
Card Type : RPM - Route Processor Module (C9000-RPM-2.56T)
Hardware Rev : 4.0
Num Ports : 1
Up Time : 25 min, 39 sec
Last Restart : normal power-cycle
Dell Networking OS Version : 1-0(0-4058)
Jumbo Capable : yes
CP Boot Flash : 3.3.1.15
RP Boot Flash : 3.3.1.15
Boot Selector : 3.3.0.0g
RP Boot Selector : 3.3.0.0g
CP Mem Size : 2127536128 bytes
RP Mem Size : 2127536128 bytes
Temperature : 29C 52C
Power Status : AC
Voltage : ok
Serial Number : NA
Part Number : 0CKKCP
Vendor Id : NA
Date Code : NA
Country Code : NA
Piece Part ID : CN-0CKKCP-77931-45N-0008
PPID Revision : X00
Service Tag : 12GQG02
Expr Svc Code : 232 582 233 8
Auto reboot : Enabled
--
Minor
78 99
Minor
35 40
Minor
60 65
2 3 4
47 - -
[booted]
[booted]
Rev X00
Major Off Major
84 105
Major Off Major
43 48
Major Off Major
72 75
--
5 6 7
- - -
Shutdown
110
Shutdown
NA
Shutdown
105
8 9
42
Debugging and Diagnostics 381