Table of Contents
Advertisement
Mapping dot1p Values to Service Queues
All traffic is by default mapped to the same queue, Queue 0.
If you honor dot1p on ingress, you can create service classes based the queueing strategy in
Honoring dot1p Values on Ingress
following command from CONFIGURATION mode.
•
All dot1p traffic is mapped to Queue 0 unless you enable service-class dynamic dot1p on an
interface or globally.
•
Layer 2 or Layer 3 service policies supersede dot1p service classes.
•
Create service classes.
INTERFACE mode
service-class dynamic dot1p
Guaranteeing Bandwidth to dot1p-Based Service Queues
To guarantee bandwidth to dot1p-based service queues, use the following command.
Apply this command in the same way as the bandwidth-percentage command in an output QoS policy
(refer to
Allocating Bandwidth to
mode supersedes the service-class bandwidth-percentage command.
•
Guarantee a minimum bandwidth to queues globally.
CONFIGURATION mode
service-class bandwidth-percentage
Applying an Input Policy Map to an Interface
To apply an input policy map to an interface, use the following command.
You can apply the same policy map to multiple interfaces, and you can modify a policy map after you apply it.
•
You cannot apply a class-map and QoS policies to the same interface.
•
You cannot apply an input Layer 2 QoS policy on an interface you also configure with vlan-stack access.
•
If you apply a service policy that contains an ACL to more than one interface, the system uses ACL
optimization to conserve CAM space. The ACL optimization behavior detects when an ACL exists in the
CAM rather than writing it to the CAM multiple times.
•
Apply an input policy map to an interface.
INTERFACE mode
service-policy input
Specify the keyword layer2 if the policy map you are applying a Layer 2 policy map; in this case,
INTERFACE mode must be in Switchport mode.
Creating Output Policy Maps
1
Create an output policy map.
CONFIGURATION mode
Packets. You may apply this queuing strategy globally by entering the
Queue). The bandwidth-percentage command in QOS-POLICY-OUT
Quality of Service (QoS)
921
Advertisement
Table of Contents
Troubleshooting
