Configuring The Lpm Table For Ipv6 Extended Prefixes - Dell C9000 Series Networking Configuration Manual

Feature and Functionality
Secure Shell (SSH) client support
over IPv6 (outbound SSH) Layer 3
only
Secure Shell (SSH) server support
over IPv6 (inbound SSH) Layer 3
only
IPv6 Access Control Lists
IPv6 Multicast
MLDv1/v2
Configuring the LPM Table for IPv6
Extended Prefixes
The LPM CAM table consists of two partitions: Partition I for IPv6 /65-/128 route-prefix entries and Partition II
for IPv6 0/0-/64 and IPv4 0/0-0/32 route-prefix entries. You must reconfigure LPM CAM to allow
IPv6 /65-/128 route prefixes to be stored in Partition I.
• Use the cam-ipv6 extended-prefix command to enable IPv6 /65-/128 route prefixes to be stored
in LPM CAM Partition 1. You must specify the maximum number of IPv6 prefixes with /65-/128 mask
length that are supported in the partition. The valid values are 1024, 2048 or 3072 prefixes. You must
save the configuration and reload the switch for the change to take effect.
• The number of entries in Partition II is reduced as the number of entries in Partition I increases.
• To disable LPM CAM partitioning and return the number of the IPv6 /65-/128 route prefixes stored in
Partition 1 to 0, enter the no cam-ipv6 extended-prefix command.
• Use the show cam-ipv6 extended-prefix command to display the currently configured number of
IPv6 /65-/128 prefixes that can be stored in LPM CAM Partition 1 and the number that are supported
after the next switch reboot.
Dell Networking OS Release
Introduction
8.3.11
8.3.11
8.3.11
N/A
Documentation and Chapter
Location
Control and Monitoring in the Dell
Networking OS Command Line
Reference Guide.
Secure Shell (SSH) Over an IPv6 Transport
Secure Shell (SSH) Over an IPv6 Transport
IPv6 Access Control Lists in the Dell
Networking OS Command Line
Reference Guide.
IPv6 PIM in the Dell Networking OS
Command Line Reference Guide.
IPv6 Routing 569