Configure Static Routes For The Management Interface; Enabling Directed Broadcast; Resolution Of Host Names - Dell C9000 Series Networking Configuration Manual

Hide thumbs Also See for C9000 Series:

Table of Contents

Configure Static Routes for the

Management Interface

When an IP address that a protocol uses and a static management route exists for the same prefix, the

protocol route takes precedence over the static management route.

To configure a static route for the management port, use the following command.

Assign a static route to point to the management interface or forwarding router.

CONFIGURATION mode

management route ip-address mask {forwarding-router-address | ManagementEthernet

Example of the show ip management-route Command

To view the configured static routes for the management port, use the show ip management-route

command in EXEC privilege mode.

Dell#show ip management-route

10.11.0.0/16

172.16.1.0/24

By default, the system drops directed broadcast packets destined for an interface. This default setting

provides some protection against denial of service (DoS) attacks.

To enable the switch to receive directed broadcasts, use the following command.

Enable directed broadcast.

INTERFACE mode

ip directed-broadcast

To view the configuration, use the show config command in INTERFACE mode.

Domain name service (DNS) maps host names to IP addresses. This feature simplifies commands such as

Telnet and FTP by allowing you to enter a name instead of an IP address.

Dynamic resolution of host names is disabled by default. Unless you enable the feature, the system resolves

only host names entered into the host table with the ip host command.

ManagementEthernet 0/0

Route Source

------------

IPv4 Routing

Troubleshooting