Dell C9000 Series Networking Configuration Manual page 811

Ineffective PBR Exception due to Low Sequence Number
ip redirect-list rcl0
seq 5 redirect 2.2.2.2 ip any any
seq 10 permit ip host 3.3.3.3 any
To ensure that the permit statement or PBR exception is effective, use a lower sequence number, as shown
below:
ip redirect-list rcl0
seq 10 permit ip host 3.3.3.3 any
seq 15 redirect 2.2.2.2 ip any any
Apply a Redirect-list to an Interface using a Redirect-group
IP redirect lists are supported on physical interfaces as well as VLAN and port-channel interfaces.
NOTE: When you apply a redirect-list on a port-channel, when traffic is redirected to the next hop and
the destination port-channel is shut down, the traffic is dropped.
Use the following command inINTERFACE mode to apply a redirect list to an interface. Multiple redirect-lists
can be applied to a redirect-group. It is also possible to create two or more redirect-groups on one interface
for backup purposes.
Table 64. Applying a Redirect-list to an Interface
Command Syntax
ip redirect-group redirect-list-name
In this example, the list "xyz" is applied to the tenGigabitEthernet 2/1 interface.
Applying a Redirect-list to an Interface Example:
Dell(conf-if-te-1/1/1)#ip redirect-group test
Dell(conf-if-te-1/1/1)#ip redirect-group xyz
Dell(conf-if-te-1/1/1)#show config
!
interface TenGigabitEthernet 1/1/1
no ip address
ip redirect-group test
ip redirect-group xyz
shutdown
Dell(conf-if-te-1/1/1)#
Command Mode Purpose
INTERFACE Apply a redirect list (policy-based routing) to
an interface.
redirect-list-name is the name of a redirect list
to apply to this interface.
FORMAT: up to 16 characters
Delete the redirect list from this interface with the [no] ip redirect-
group command.
Policy-based Routing (PBR) 811