Dell C9000 Series Networking Configuration Manual page 637

The following figure illustrates inspecting the LAG Status Using the show lacp command.
Figure 68. Inspecting the LAG Status Using the show lacp command
The point-to-point protocol (PPP) is a connection-oriented protocol that enables layer two links over various
different physical layer connections. It is supported on both synchronous and asynchronous lines, and can
operate in Half-Duplex or Full-Duplex mode. It was designed to carry IP traffic but is general enough to allow
any type of network layer datagram to be sent over a PPP connection. As its name implies, it is for point-to-
point connections between exactly two devices, and assumes that frames are sent and received in the same
order.
Link Aggregation Control Protocol (LACP) 637