Dell C9000 Series Networking Configuration Manual page 879

Power Reserved for inline Power:
Total Inline Power Consumed:
Remaining inline power Available:
Power Management Mode:
Interface Inline Power
Max / Alloc
(Watts)
------------- ------------
PeGi 255/0/1 30.00/21.40
Example of Configuring Port Extender Interfaces with a Maximum Power of 15000 and 5000 mW
The following example sets the maximum allocated power to 15000 mW on interface peGigE 0/0/1 and
5000 mW on interface peGigE 0/0/2 interface peGigE 0/0/3 is not configured. The default value of 30000
mW is the maximum power that you can allocate to a device.
This configuration has the following PoE topology:
Figure 112. PoE Topology
Dell(conf)#interface peGigE 0/0/1
Dell(conf-if-pegi-0/0/1)#power inline
Dell(conf)#interface peGigE 0/0/2
Dell(conf-if-pegi-0/0/2)#power inline 15000
Dell(conf)#interface peGigE 0/0/3
Dell(conf-if-pegi-0/0/3)#power inline 5000
1612W
21W
1580W
Class
Inline Power Class
Consumed
(Watts)
------------ -------
21.50
Device PoE Port
Type Priority
------ --------
4 2 low
Power over Ethernet (PoE)
LLDP
Support
------
0
879