Table of Contents
Advertisement
redistribute ospf process-id [match external {1 | 2} | match internal] [metric
value] [route-map map-name]
Configure the following parameters:
•
process-id: the range is from 1 to 65535.
•
metric: the range is from 0 to 16.
•
map-name: the name of a configured route map.
To view the current RIP configuration, use the show running-config command in EXEC mode or the show
config command in ROUTER RIP mode.
Setting the Send and Receive Version
To change the RIP version globally or on an interface, use the following command.
To specify the RIP version, use the version command in ROUTER RIP mode. To set an interface to receive
only one or the other version, use the ip rip send version or the ip rip receive version
commands in INTERFACE mode.
You can set one RIP version globally on the system using system. This command sets the RIP version for RIP
traffic on the interfaces participating in RIP unless the interface was specifically configured for a specific RIP
version.
•
Set the RIP version sent and received on the system.
ROUTER RIP mode
version {1 | 2}
•
Set the RIP versions received on that interface.
INTERFACE mode
ip rip receive version [1] [2]
•
Set the RIP versions sent out on that interface.
INTERFACE mode
ip rip send version [1] [2]
Examples of Setting the RIP Process
To see whether the version command is configured, use the show config command in ROUTER RIP
mode. To view the routing protocols configuration, use the show ip protocols command in EXEC mode.
The following example shows the RIP configuration after the ROUTER RIP mode version command is set
to RIPv2. When you set the ROUTER RIP mode version command, the interface (TengigabitEthernet 0/0)
participating in the RIP process is also set to send and receive RIPv2 (shown in bold).
Dell#show ip protocols
Routing Protocols is RIP
Sending updates every 30 seconds, next due in 23
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control: receive version 2, send version 2
Interface
Recv
Send
Routing Information Protocol (RIP)
944
Advertisement
Table of Contents
Troubleshooting
